Monitor TAD-214-W300, Инструкция по установке и руководство по эксплуатации

Страница: 52 / 80

48
10.1.10 – To check a channels configuration: -
10.1.10.1. - Secret, channel
10.2. - Sleep Safe Mode Set Up
(not Monitor I)
10.2.1. - Channels can be set to NOT ARM
when the system is ‘Part
Armed’. This feature can be used to set up a Part Armed ‘Sleep Safe’ state
that protects the boat whilst on board (e.g. sleeping).
10.2.2. -
To achieve this Sensors that trigger when detecting ‘in side’
movement should have their channels configured to a Sleep Safe (SS)
mode (configuration code 7, 8 or 9 see Table 10.1.3.1.).
10.2.3. - To configure a channel to Sleep Safe mode send the following
message (In the example shown below a Wireless PIR has been assigned to
wireless channel 16, the channel is configured to a Alarm Normally Closed
Sleep Safe (NC SS) configuration and will be called ‘Bed1 PIR SS’ and its RF
code is 23948).
10.2.3.1. - Secret, channel, 16, 7, Bed1 PIR SS, 23948
10.3. - Configure Dead Time
10.3.1. - The Dead Time is the duration the system will ignore the sensors
after it has been triggered. The Dead Time is measured in minutes and has
a maximum duration of 240 minutes (4 hours). If set to 255 minutes the
unit will ignore the sensor (after it has been triggered) until the alarm has
been disarmed and rearmed.
10.3.2. - To configure the Dead Time send the following message (In the
example below the Dead Time has been set to 5 minutes): -
10.3.2.1. - Secret, time, 5
10.3.3. - To check the Dead Time send the following message: -
10.3.3.1. - Secret, time