Monarch NICE7000, Руководство пользователя

Страница: 190 / 237

7 Description of Function Codes NICE7000 User Manual
- 188 -
causing incorrect calculation of certain variables and reducing the control effect.
The system automatically performs zero drift detection on the SIN/COS encoder ABCD
analog signals.
If the encoder needs to be replaced after motor auto-tuning, manually clear the zero drift
values first.
Function Code Parameter Name Setting Range Default Unit Property
FH-17 Position of up slow-down 1 0.000–300.00 0.00 m
★
FH-18 Position of down slow-down 1 0.000–300.00 0.00 m
★
FH-19 Position of up slow-down 2 0.000–300.00 0.00 m
★
FH-20 Position of down slow-down 2 0.000–300.00 0.00 m
★
FH-21 Position of up slow-down 3 0.000–300.00 0.00 m
★
FH-22 Position of down slow-down 3 0.000–300.00 0.00 m
★
These parameters specify the positions of all slow-down switches relative to the top and
bottom leveling positions.
For the installation positions of the slow-down switches, see the description of section 3.10.
Function Code Parameter Name Setting Range Default Unit Property
FH-29 Position switch signal delay 0–200 0 ms
★
It is used to set the delay from receiving the shaft position switch signal to responding.
Group FL: Extension Terminal Function Parameters
Function Code Parameter Name Setting Range Default Unit Property
FL-00 CTB input type 0–511 320 -
★
It is used to define the input signal type (NO/NC) of the CTB by binary bit. Each bit of the
function code defines a signal, as described in the following table.
If a bit is set to 1, the signal indicated by this bit is NO input; if this bit is set to 0, this signal
is NC input.
For example, the input signal types of the CTB of an elevator are set as follows:
Bit Parameter Name Default Bit Parameter Name Default
Bit0 Door 1 light curtain 0 Bit5 Door 2 close limit 0
Bit1 Door 2 light curtain 0 Bit6 Full-load signal (digital) 1
Bit2 Door 1 open limit 0 Bit7 Overload signal (digital) 0
Bit3 Door 2 open limit 0 Bit8 Light-load signal (digital) 1
Bit4 Door 1 close limit 0 0: NC input; 1: NO input
Convert the binary value to decimal 320, and set it on the operation panel.