Monarch NICE7000, Руководство пользователя

Страница: 150 / 237

7 Description of Function Codes NICE7000 User Manual
- 148 -
Note
Functions 04 (Safety circuit feedback signal), 05 (Door lock circuit feedback signal), 06 (RUN
contactor feedback signal), and 07 (Brake contactor feedback signal) can be selected repeatedly.
The hundred's digit indicates the NO/NC type (1: NC, 0: NO), and the lowest two digits indicate
the selected function. For example, if X13 is used for inspection signal NC input, set F5-13 to 108;
if X14 is used for inspection up signal NO input, set F5-14 to 009.
Terminals X1 to X20 are digital inputs, and are allocated with corresponding functions
based on the input signals. After the 24 V voltage is input, the corresponding input terminal
indicator becomes ON. The functions are described as follows:
00: Invalid
Even if there is signal input to the terminal, the system has no response. You can allocate
this function to terminals that are not used to prevent mis-function.
01: Up leveling signal 02: Down leveling signal 03: Door zone signal
The NICE7000 system determines the elevator leveling position based on the leveling
sensor signal. The system supports three types of leveling configuration: single door zone
sensor, up and down leveling sensors, and door zone sensor plus the up/down leveling
sensor.
The following table describes the sequence of received signals for the three types of leveling
configurations.
Leveling Configuration
Signal Receiving Sequence
Up leveling
sensor
Down leveling
sensor
Door zone
sensor
Up direction Down direction
No No Yes Door zone signal
Yes Yes No
Up leveling signal
---> Down leveling
signal
Down leveling signal --->
Up leveling signal
Yes Yes Yes
Up leveling signal
---> Door zone signal
---> Down leveling
signal
Down leveling signal --->
Door zone signal ---> Up
le veling signal
If the leveling signal is abnormal (stuck or unavailable), the system reports fault Err22.
04: Safety circuit feedback signal 05: Door lock circuit feedback signal
The safety circuit is important to safe and reliable running of the elevator, and the door lock
circuit ensures that the hall door and car door are closed before the elevator starts to run.
Valid feedback signals of the safety circuit and door lock circuit are necessary to elevator
running.
It is recommended that these signals are set to NO input. If they are set to NC input, the
system considers the input active even though there is no input. In this case, the actual state
of the safety circuit cannot be detected, which may cause potential safety risks.
06: RUN contactor feedback signal 07: Brake contactor/Brake detection switch