Monarch NICE7000, Руководство пользователя

Страница: 180 / 237

7 Description of Function Codes NICE7000 User Manual
- 178 -
Figure 7-7 Shift between parameters displayed in the stop state
Bus voltage
Current floor
Current position
Car load
Slow-down distance
Encoder signal
1
Encoder signal
2
Encoder signal
3
Encoder signal
5
Encoder signal
6
Rated elevator speed
Encoder signal
4
Shift between parameters
displayed in the stop state
Bit0 Bit1 Bit2 Bit3 Bit4 Bit5 Bit6 Bit7 Bit8 Bit9 Bit10 Bit11
Function Code Parameter Name Setting Range Default Unit Property
FA-03 Product SN 1–7000 5000 -
●
It displays the product SN.
Function Code Parameter Name Setting Range Default Unit Property
FA-04 Software version 1 (CTB) 0–65535 0 -
●
FA-05 Software version 2 (MCB) 0–65535 0 -
●
FA-06
Software version 3 (drive
board software)
0–65535 0 -
●
These two parameters respectively display the program version number of the CTB, logic
control board and the drive control board.
Function Code Parameter Name Setting Range Default Unit Property
FA-07 Heatsink temperature 0–100 0 °C
●
It displays the current temperature of the heatsink.
Normally, the heatsink temperature is below 40°C. When the heatsink temperature is too
high, the system lowers the carrier frequency automatically to reduce heating. When the
heatsink temperature rises to a certain value, the system reports the module overheat fault
and stops running.
Function Code Parameter Name Setting Range Default Unit Property
FA-09 Protection function selection 0–65535 3 -
★
It is used to select the controller protection functions.
Each bit of the function code defines a function, as described in the following table.
If a bit is set to 1, the function indicated by this bit is enabled; if this bit is set to 0, the
function is disabled.
The functions defined by the binary bits are described in the following table.