2 Installation Procedures
c
Connect the quarter-turn fasteners to the bottom of the fluidics module. Lock the
fasteners into place.
3 Attach electrical connector.
a
Hold fluidics module tilted back with your left hand, and use your right hand to
connect the 15-pin sub-D electrical connector. The connector fits into the
communication port on the far bottom edge of the fluidics module. It must be
aligned properly to fit.
b
Press connector in firmly.
c
Secure two communication port screws lightly with your fingers.
FLUIDICS
CONNECTOR
CONNECT
FLUIDICS HERE
Note:
There are labels on both the fluidics connector [‘Fluidics Connector’]
and near the communication port [‘Connect Fluidics Here’] that help
identify these parts.
4 Lower fluidics module into place.
Caution:
Be careful when lowering the fluidics module that you do not trap or compress
any of the optical fibers coming up from the detection module.
a
Ensure that all cables and wires are tucked out of the way.
b
Gently lower the fluidics module by the handle down over the detection module and
onto the locating pins.
c
Check that the fluidics module sits securely on the detection module.
Caution:
When installing the fluidics module, ensure module is firmly seated.
36
FlexStation II Operator’s Manual – Rev. D
Содержание FlexStation II
