Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 538 / 1308

CLUTCH
Clutch pedal clevis pin play and
clutch pedal free play
Distance between the clutch
pedal and the when the
clutch is disengaged
Good
No good
When engine is
stopped engine is
started
4. Measure the clutch pedal clevis pin play.
If the clutch pedal clevis pin play is outside the standard
value, adjust with the push rod.
5. Measure pedal play. In the case of AWD vehicles, depress
the pedal 2 or 3 times to eliminate booster negative pres-
sure with the engine stopped and then push the pedal
with a finger to measure the play.
6.
Measure the clearance to the toe board (or pedal stopper)
when the clutch disengages. In the case of AWD vehicles,
measure with the engine running.
7. If the play and/or clearance is out of specification, bleed
the hydraulic system or check the master cylinder, release
cylinder or clutch proper.
8. Return the carpet to the original position.
CLUTCH BOOSTER OPERATING CHECK
For simple checking of clutch booster operation, carry out
the following tests.
(1) Run the engine for one or two minutes, and then stop
it.
(2) Step on the clutch pedal several times with normal pres-
sure.
If the pedal depressed fully the first time but gradually
becomes higher when depressed succeeding times, the
booster is operating properly.
If the pedal height remains unchanged, the booster is
faulty.
(3) With the engine stopped, step on the clutch pedal several
times with the same foot pressure to make sure that
the pedal height will not change.
Then step on the clutch pedal and start the engine.
If the pedal moves downward slightly, the booster is in
good condition. If there is no change, the booster is faulty.