Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 690 / 1308

FRONT AXLE
Drive Shaft
B.J. boot band
(5) Install the boot band (small) against the projection at
the boot end to provide clearance A as shown in the
illustration.
(6) Using the special tool, crimp the boot band.
Caution
1. With the drive shaft secured vertically, pinch
positively the portion to be crimped of the band
between the tips of the special tool.
2. Be sure to compress the boot band until the
special tool handle comes in contact with the
stopper.
(7) Make sure that the amount of boot band crimping (B)
is of the standard value.
Standard value (B): 2.8 mm in.)
<When amount of crimping is above 2.8 mm
in.)>
Readjust W given in (4) above to the value
calculated by the following formula, and repeat
work described in (6).
W 5.5 mm
in.) B
[Example: When B
mm
in.)]
2.9 mm in.), W 2.6
amount of crimping is below 2.4 mm
in.)>
Remove the boot band, readjust W given in (4)
to the value calculated by the following formula
and repeat work described in (5) and (6) by using
a new boot band.
W 5.5 mm
in.) B
[Example: When B
mm
in.)]
2.3 mm in.), W 3.2
(8) Make sure that the boot band does not protrude from
the band mounting area. If the band protruds, replace
it with a new band and repeat work described in (5) through
(7).
(9) Pack the boot with specified amount of grease to
specification.
Specified grease: Grease in repair kit
Amount applied: 155 g (5.47 oz.)
TSB Revision