Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1036 / 1308

BODY
Windshield
Matchmarks
REMOVAL SERVICE POINT
WINDSHIELD GLASS REMOVAL
Remove windshield using the following procedure.
(1) For protection of the body (coated surface), apply cloth
tape to all around the body where the glass is installed.
(2) Using a drill of sharp bit, drill a hole through the adhesive
fixing the windshield glass.
(3) Run a wire through the hole from inside of the
compartment.
(4) Pull the wire alternately from inside and outside of the
compartment to cut off the adhesive.
Caution
Be careful to prevent contact of the wire with the
windshield glass edge.
(5) Put matchmarks on the body and the glass.
(6) Using the special tool, remove the windshield glass.
(7) Using a sharp knife, scoop out existing adhesive from
the body flange to 2 mm in.) or less thickness all
around the window opening.
(8) Finish smooth the flange surfaces.
Caution
1.
Do not remove the adhesive more than necessary.
2. Be careful not to damage the coated surface of
the body with the knife. If it is damaged, apply
retouch paint of anti-corrosive.
(9) If the glass is reused, scoop out existing adhesive and
fragments of the window dam completely from the glass
and degrease with 3M ATD Part No. 8906 or equivalent.
(lO)Degrease the body same way.
Caution
After degreasing, allow three minutes or more to dry
well before next work. Do not touch the degreased
surface.
TSB Revision