Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1019 / 1308

BODY
On-vehicle Service
42-13
mm in.)
14.5 mm in.)
8. Adjust glass to have standard clearance between the weatherstrip holder and window glass.
5. Remove the stabilizer inner front and adjust the adjusting
bolt for the dimension shown here.
6. Adjust the adjusting bolt for the stabilizer inner rear dimen-
sion shown here.
7. Raise door window glass. Push glass against the outer
stabilizer of the door belt line outer weatherstrip and insert
cloth or the like between the door inner panel and glass.
Measure the clearance, specified in section A-A, B-B and C-C, at the corresponding weatherstrip
holder screws as shown in the illustration.
W eatherstrip
Section A-A Section B-B Section C-C
Adjustment Adjustment procedures Standard value mm (in.)
Adjust by turning the
Section A-A (1): 1.0
Adjust-
ing bolts of the glass guide
ment of
front track and glass guide
1 inward
rear track.
Section B-B
(1): 11.8 1
tilt of
Caution
glass
Turn the two adjusting
bolts of the glass guide
rear track same amount.
Section C-C
(1): 20.5 1
Move the stabilizer inner
front and up stop up and
down to adjust the forward
or rearward tilt of glass
when glass is fully closed.
Section A-A
Section B-B
(2): 7.0 1
(2): 7.7 1
Do not turn the stabilizer
inner front adjusting bolt.
Section C-C (2): 12.0 1
NOTE
Adjust both inward tilt and forward or backward tilt of glass at the same time.
TSB Revision