Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1096 / 1308

EXTERIOR Windshield Wiper and Washer
Identification mark: A
Identification mark: D
Front deck garnish
Inspection of Operation
Low-speed High-speed
operation
operation
Inspection of Stop Position
00002340
REMOVAL SERVICE POINT
WIPER MOTOR REMOVAL
(1) Remove the wiper motor mounting bolts.
(2) Using a plain screwdriver, detach the crank arm of the
wiper motor from the linkage to remove the wiper motor.
Caution
Do not remove the crank arm from the wiper motor
except when necessary, as the auto stop angle has
been preset. When the crank arm is to be removed,
make
a mark on both of them before removal.
INSTALLATION SERVICE POINT
WIPER ARM INSTALLATION
(1) The wiper arms, right and left, are different in shape.
Check the identification symbol.
(2) After the wiper blades have been set, install them in such
a way that the ends of the wiper blades will stop at the
specified positions (standard values).
Standard value (A): mm in.)
INSPECTION
WIPER MOTOR CHECK
Inspect the wiper motor mounted on the vehicle with its con-
nector disconnected.
Wiper Motor Operation at LOW and HIGH Speeds
Check
Connect the battery to the wiper motor as shown, and check
its operation at LOW and HIGH speeds.
Wiper Motor STOP Position Check
(1) Operate the wiper motor at LOW speed and intermediately
disconnect the battery to let the wiper motor stop.
(2) Connect the terminals as well as the battery, as shown,
and check that the wiper motor stops at the
stopped position following LOW-speed operation.
COLUMN SWITCH CHECK
(1) Remove the knee protector.
(Refer to GROUP 52A Instrument Panel.)
(2) Remove the column cover.
(3) Remove the column switch right coupling connector (11
terminals).
TSB Revision