Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1208 / 1308

SRS Air Bag Module and Clock Spring
REMOVAL SERVICE POINTS
NEGATIVE BATTERY CABLE
DISCONNECTION
Battery
Turn the ignition key to the “LOCK” position, disconnect the
negative battery cable from the battery and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. The
system
is designed to retain enough voltage to deploy the air
bag even after the battery has been disconnected. Serious
injury may result from unintended air bag deployment
if work is done on the SRS system immediately after
the battery cable is disconnected.
AIR BAG MODULE (DRIVER’S SIDE) REMOVAL
(1) Remove the air bag module mounting nut using a socket
wrench from the back side.
Pad cover
(2) When disconnecting the connector of the clock spring
from the air bag module, press the air bag’s lock toward
the outer side to spread it open. Use a screwdriver, as
shown in the figure at the left, to pry so as to remove
the connector gently.
Caution
1. When disconnecting the air bag module-clock
spring connector, take care not to apply excessive
force to it.
2. The removed air bag module should be stored
in a clean, dry place with the pad cover face up.
driver
STEERING WHEEL REMOVAL
Remove the steering wheel by using the special tool.
Caution
Do not hammer on the steering wheel. Doing so may
damage the collapsible column mechanism.
DIAGNOSIS UNIT AND CLOCK SPRING
DISCONNECTION
(1) Release the lock of SDU connector in accordance with
the following procedure:
In case that there is no notch on the lock lever
Place a flat tip screwdriver against the lock spring (metal
section) of the connector lock lever as shown in the
illustration, and push the spring horizontally toward the
inside of the unit.
TSB Revision