Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 970 / 1308

STEERING
On-vehicle Service
Fluid fluctuation
- - - - -
- - -
- -
While engine
While engine
running stopped
3
Return hose
Vinyl hose
FLUID LEVEL CHECK
1. Park the vehicle on a flat, level surface, start the engine,
and then turn the steering wheel several times to raise
the temperature of the fluid to approximately
2. With the engine running, turn the wheel all the way to
the left and right several times.
3.
Check the fluid in the oil reservoir for foaming or milkiness.
Check the difference of the fluid level when the engine
is stopped, and while it is running. If the fluid level changes
considerably, air bleeding should be done.
F L U I D R E P L A C E M E N T
1. Raise the front wheels on a jack, and then support them
with rigid racks.
2. Disconnect the return hose connection.
3. Connect a vinyl hose to the return hose, and drain the
oil into a container.
4. Disconnect the high-tension cable, and then while operat-
ing the starting motor intermittently, turn the steering wheel
all the way to the left and right several times to drain
all of the fluid.
Caution
Be careful not to position the high-tension cable near
the carburetor or the delivery pipe.
5. Connect the return hoses securely, and then secure it
with the clip.
6. Fill the oil reservoir with the specified fluid up to the lower
position of the filter, and then bleed the air.
Specified fluid:
Automatic transmission fluid “DEXRON II”
TSB Revision