Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1175 / 1308

SRS Troubleshootina
CONTINUED FROM PREVIOUS PAGE
Insulating tape
(1) Turn the ignition key to the “LOCK” position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work. The SRS
system is designed to retain enough voltage to deploy
the air bag even after the battery has been discon-
nected. Serious injury may result from unintended
air bag deployment if work is done on the SRS system
immediately after the battery cable is disconnected.
(2) Remove the rear console assembly.
Battery
(Refer to GROUP 52A Floor Console.)
(3) Release the lock of SDU connector in accordance with
the following procedure:
In case that there is no notch on the lock lever
Place a flat tip screwdriver against the lock spring (metal
section) of the connector lock lever as shown in the
illustration, and push the spring horizontally toward the
inside of the unit.
Caution
1.
Do not use excessive force to raise the lock lever.
2. Do not insert the screwdriver into the gap between
the lock lever and the lock spring.
In case that there is a notch on the lock lever
Place a flat tip screwdriver against the lock spring (metal
section) at the lock lever notch as shown in the illustration,
and push the spring toward the unit.
Caution
Do not use excessive force to raise the lock lever.
CONTINUED ON NEXT PAGE
TSB Revision