Mitsubishi 1992 3000GT, Руководство по обслуживанию

Страница: 1060 / 1308

42-54
BODY Entry System
Code
(3) Set the code registration switch of the receiver to the
FIX position (operation mode).
(4) Confirm that the entry system operates normally.
The registration is completed if the system operates
mally. If not, repeat the steps (1) through (3).
NOTE
tool
I
(1) In case there are two transmitters, register the code
on the SET II side in the same manner as the SET
I side. In addition, even if there is only one transmitter,
register the code on SET I and SET to prevent
malfunction.
(2) Make sure that after a code has been registered,
the registration switch is set to the FIX position posi-
tively.
1996 models>
Since the transmitter is memorized by each individual code,
it is necessary to register a code on EEPROM in the receiver
if the transmitter or receiver is replaced, or cause of the trouble
is presumed to be due to faulty registration of the code. Since
two different codes at the most can be memorized in the
memory space of EEPROM, the old code will become unable
to be used if the following registration operation is repeated
twice. Meanwhile, register a code after confirming that an
ordinary door lock function can be worked through key
operation.
(1) Connect the scan tool to the data link connector.
NOTE
This grounds the data link connector No. 1 and gets
ready for a code registration.
Caution
Turn the ignition switch to OFF before connecting
or disconnecting the scan tool.
(2) Close all doors.
(3) Turn the ignition switch to ACC and return it to OFF.
NOTE
This locks and unlocks the door once, and then a code
can be registered.
(4) After pressing any switch on the transmitter once, press
it two more times within 10 seconds to register the same
code for SET I and SET II.
(5) After registration is completed, the door will be locked
and unlocked once.
Revision