Mitsubishi Electric MR-J5 Series, Руководство пользователя

Страница: 29 / 316

3 SIGNALS AND WIRING
3.1 Connection example of power circuit
27
3
*1 For the power supply specifications, refer to "Servo amplifier standard specifications" in the following user's manuals.
 MR-J5-G/MR-J5W-G User's Manual (Introduction)

MR-J5-A User's Manual (Introduction)
*2 Use a magnetic contactor with an operation delay time (interval between current being applied to the coil until closure of contacts) of 80
ms or less (160 ms or less for 5 kW or more). Bus voltage may drop depending on the main circuit voltage and operation pattern,
causing a dynamic brake deceleration during a forced stop deceleration. If dynamic brake deceleration is not required, delay the time to
turn off the magnetic contactor.
*3 Operating the on switch and off switch with the DC power supply meets IEC/EN 60204-1 requirements.
*4 Do not share the 24 V DC power supply for interface with a magnetic contactor. Always use the power supply designed exclusively for
the magnetic contactor.
*5 If wires used for L11 and L21 are thinner than wires used for L1, L2, L3, and N-, use a fuse.
 Page 170 When using the servo amplifier with the DC power supply input
Power supply capacity
The power supply capacity is the same as that for the AC power supply input.

Page 97 Power supply capacity and generated loss
Selection example of wires
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wiring length: 30 m or shorter
The following shows the wires used for wiring. Use the wires given in this section or equivalent wires.
■
Example of selecting the wire sizes
Use 600 V Grade heat-resistant polyvinyl chloride insulated wires (HIV wires) for wiring. The following shows the wire size
selection example.
Servo amplifier Wire [mm
2
]
L1/L2/L3/N-/ L11/L21
MR-J5-10_ 2 (AWG 14) 1.25 to 2
(AWG 16 to 14)
MR-J5-20_
MR-J5-40_
MR-J5-60_
MR-J5-70_
MR-J5-100_
MR-J5-200_ 3.5 (AWG 12)
MR-J5-350_
MR-J5W2-_G 2 (AWG 14) 2 (AWG 14)
MR-J5W3-_G