Mitsubishi Electric MR-J5 Series, Руководство пользователя

Страница: 48 / 316

46
3 SIGNALS AND WIRING
3.3 Explanation of power supply system
Connecting wires
■
Fabricating wire insulator
Refer to the following for the stripped length of the wire insulator. Set the appropriate length based on the wire type and
fabrication condition.

Page 44 Connector
Twist the core wires lightly and straighten them as follows.
You can also use a ferrule to connect with the connectors. If you use the ferrule, use the following ferrules and crimping tool.
■ Inserting wire
Insert only one wire or ferrule into each wire insertion hole on each power connector.
Insert the open tool as follows and push it down to open the spring.
While the open tool is pushed down, insert the stripped wire into the wire insertion hole. Check the wire insertion depth so that
the wire insulator is not caught by the spring and that the conductive part of the stripped wire is not exposed.
Release the open tool to fix the wire. Pull the wire lightly to confirm that the wire is surely connected. In addition, confirm that
the ends of the core wires do not stick out of the connector.
Servo amplifier Wire size Ferrule model (Phoenix Contact) Crimping tool (Phoenix
Contact)
For one wire For two wires
MR-J5-10_ to
MR-J5-100_
MR-J5W2-_G
MR-J5W3-_G AWG 16 AI1.5-10BK AI-TWIN2

1.5-10BK CRIMPFOX-ZA3
AWG 14 AI2.5-10BU

MR-J5-200_ to
MR-J5-350_ AWG 16 AI1.5-10BK AI-TWIN2

1.5-10BK
AWG 14 AI2.5-10BU AI-TWIN2

2.5-10BU
AWG 12 AI4-10GY

Insulator
Core
Stripped length
Loose and bent strands Twist and straighten the strands.
1) Push down the open tool.
3) Release the open tool to fix the wire.
2) Insert the wire.