Mitsubishi Electric MR-J5 Series, Руководство пользователя

Страница: 263 / 316

9 USING A LINEAR SERVO MOTOR
9.5 Adjustment
261
9
9.5
Adjustment
Auto tuning function
Although the auto tuning function during the linear servo motor operation is the same as that of the rotary servo motor, the
calculation method of the load to motor mass ratio (J ratio) is different. The load to motor mass ratio (J ratio) on the linear
servo motor is calculated by dividing the load mass by the mass of the linear servo motor primary side.
Ex.
Mass of linear servo motor primary side = 2 kg
Load mass (excluding the mass of the linear servo motor primary side) = 4 kg
Mass ratio = 4/2 = 2 times
For other servo parameters set with the auto tuning function, refer to the following.
 MR-J5 User's Manual (Adjustment)
Precautions for the auto tuning function
If the following conditions are not satisfied, the auto tuning mode 1 may not operate properly.
• Time to reach 2000 mm/s is the acceleration/deceleration time constant of 5 s or less.
• The linear servo motor speed is 50 mm/s or higher.
• The load to mass of the linear servo motor primary-side ratio is 100 times or less.
• The acceleration/deceleration thrust is 10 % or higher of the continuous thrust.
Machine analyzer function
Perform the machine analyzer function after the magnetic pole detection. If the magnetic pole detection is not performed, the
machine analyzer function may not operate properly.
The stop position at the completion of the machine analyzer function is arbitrary.
(10) Magnetic Pole Information The magnetic pole information can be displayed and set.

(11) Parameter Setting (Electronic
gear) The servo parameters for the electronic gear ([Pr. PA06] and [Pr. PA07]) can be displayed and set.

Symbol Name Explanation Unit