Mindray Imagyn 7, Руководство оператора

Страница: 226 / 492

7 - 30 Operator’s Manual
7 3D/4D
Reference image
Tap [A], [B], or [C] to select the reference image.
Slice and slice line
• Central slice: the central slice line corresponding plane are the central slice, which is marked
with a green “*” at the upper left corner of the image.
• Tap to place the slice lines vertically, and touch to place the slice lines horizontally.
• Active slice: the green slice line corresponding plane is the active slice, which is marked with a
green box. The default active slice is the central slice.
• Slice order number: indicating the order of the slices, the order of central slice is “0”, the slices
before the central slice are marked with negative integral numbers, and the slices after the
central slice are marked with positive integral numbers.
• Slice position (to the central slice): displayed at the upper left corner of each image, indicating
the position of each image (such as -6mm, -3mm, 3mm, 6mm).
• Coordinate axis: indicated on the A, B, C three reference images, match together with the
central slice line, and will move accordingly with the central slice line.
Slice shifting
Roll the trackball to shift the crossing point of central axis up/down, left/right, and the slice lines
will shift accordingly with the crossing point.
Rotate the knob under [Range Pos] on the touch screen to fine-tune slice lines horizontally.
Slice position
Rotate the knob under [Slice Position] to move the active slice line (green) either forward or
backward within the range, then the corresponding slice will be highlighted in green.
Spacing
The value is displayed at the upper left side of the slice, unit: mm. Adjust it through touch screen
selection [Spacing].
Slices number
Change slices number as necessary using the knob under [Slices Number] on the touch screen.
Thickness
TIP:
Thickness can not be larger than Spacing.
Rotate the knob under [Thickness] to adjust the SCV thickness. When the thickness value is larger
than zero, the SCV function is on.