Mindray Imagyn 7, Руководство оператора

Страница: 203 / 492

7 3D/4D
Operator’s Manual 7 - 7
Move the probe across the body surface.
The arrow in the figure below indicates the movement of the probe.
You can move the probe in the opposite direction to the arrow.
7.3 Static 3D
Static 3D provides single frame image acquisition of 3D images. During the scanning; the probe
performs the scanning automatically.
7.3.1 Basic Procedures for Static 3D Imaging
Perform the following procedure:
1.
Select the proper probe and exam mode; make sure there is sufficient gel on the probe for
scanning.
2. Obtain a 2D image, and optimize the image if necessary.
3. Press to enter Static 3D mode, and define the ROI and curved VOI.
Methods to adjust the ROI:
– Under acquisition preparation status: Roll the trackball to change the ROI size, position
and curved VOI, press the right <Set> key to toggle among setting the ROI position, size
or curved VOI. Press the left <set> key to adjust VOI angle.
– Tap [Flip VOI] to flip VOI. Tap [Reset VOI] to reset the angle of VOI to the original
status.
– Enter touch screen mapping mode.
Draw a circle on the desired area. Move ROI over the circle to adjust the size and position
of ROI. Roll the trackball or press <Set> to adjust ROI.
1
ROI
2 Draw a circle here
3 ROI cover this area
3
1
2
澳