Page 13 of 113
•
Read and understand all maintenance instructions in this user guide before
performing maintenance on the pump. Failure to follow instructions could result
in user injury or damage to the instrument.
•
Any alteration of the pump from factory specification may cause unsafe
conditions, and will void the product warranty.
•
Any attempt to use the pump in a manner not specified in this user guide may
result in damage to the instrument, operator injury, and will void the product
warranty.
•
Do not attempt to open and repair the pump. Service should be performed by
trained and authorized personnel only.
•
Place the pump on a clean, flat, stable, horizontal surface, away from any
source of excessive heat and close to an easily accessible, properly grounded
power supply outlet.
•
Do not expose the pump or the communication hub to liquid. If this happens,
immediately switch off and disconnect the pump from the power outlet, and
then decontaminate the pump and communication hub surfaces using a wipe
moistened with one of the recommended cleaning agents listed in
.
•
Never expose the equipment to extreme temperatures. Operating temperature
must be between 15 °C and 40 °C (59 and 104 °F).
•
Use only accessories and replacement parts designed for the pump. See
Accessories and Replacement Parts
. Using accessories not designed for the
pump could result in user injury or damage to the instrument.
•
The Steritest
®
Symbio Pump has been designed to be used with the Steritest
®
devices and accessories.
•
When filtrating hazardous liquids, wear and use proper protective clothing and
equipment for the handling and the disposal of the liquid to be filtrated.
•
In case of skin contact with the filtrated liquid, refer to the safety datasheet of
the filtrated liquid for first aid measures.
•
Dispose the filtrated liquids according to local regulations.
•
Do not use the Steritest
®
Symbio Pump to filtrate flammable products.
•
Never touch the display or control panel with a sharp object.
•
Before cleaning, shut down the the Steritest
®
Symbio Pump and switch off and
disconnect the communication hub from power source.
•
The power supply must be protected by a fuse below the main connection.
•
The electrical installation must comply with local standards.
•
Use an electrical surge protector to prevent damage to the system.
•
The communication hub is a specific component of the Steritest
®
Symbio Pump
and should not be used for any other purpose.
