Micromeritics AccuPyc 1330, Руководство оператора, Страница: 42 / 115

Printing Reports
Reports are generated after analysis and calibration and remain available for
viewing or printing until another automatic operation (other than zero) is per-
formed. When you perform an automatic operation, reports from the previous
operation are deleted.
The Report Options function enables you to select the destination of the re-
port that is automatically generated after an analysis or calibration. The desti-
nation may be: display, printer, or transmission line. A display report is
always calculated regardless of the specified destination. The display report
for analyses contains average density or volume, depending on the option se-
lected (refer to Report Options), and the deviation from the mean. The
printed report contains volume, density, and deviation for each run, as well as
an average of all runs. Note that if you do not enter a sample weight, the
value shown for density will be incorrect. When sample weight is not en-
tered, 1.0000 g is used. The report also contains the date and time the analy-
sis was started and completed and the temperature of the cell chamber.
The display report for calibration contains average cell or expansion volume,
depending on the option selected (refer to Report Options), and the devia-
tion from the mean. The printed report contains cell and expansion volumes
for each run, as well as an average of all runs.
A run with an asterisk next to the run number is not included in the
calculations.
Figure 4-2 shows a calibration report. Figure 4-3 shows a report for an analy-
sis performed using the same calibration standard. Figure 4-4 shows a report
for an analysis performed with run precision enabled.
To display reports, press to cycle through messages until the report
messages are displayed.
Press to print reports. Reports are immediately sent to the
printer. If you press during an automatic operation, a partial
report is printed.
You may cancel reports sent to the printer or serial line by pressing
. You may cancel partial reports that were requested during an auto-
matic operation when the following message is displayed:
CHOICE
6
6
CLEAR
Print in progress
[Escape] to cancel
Printing Reports AccuPyc 1330
4-10 September 1996