Metal-Fach Z589, Руководство по эксплуатации и техническому обслуживанию

Страница: 40 / 145

page 37
Z589
Round Baler
7.6.5 PROTECTIVE SHIELD (Z589-2 only)
The safety guard installed on the machines with a cutting assembly optimises collection of the product and its
infeed to the machine.
You can adjust the spacing of the safety guard to the pickup prongs by shifting the buffers T.
Stop the machine and the tractor engine to:
• Remove the shield.
Remove the retaining bolt
V
of the buffer
T
and relocate the buffer to one of the holes on the pickup side as
required. Retighten the bolts
V
when finished.
IMPORTANT!
Place the buffer T on the same level on the left and right-hand side of the pickup.
• Reinstall the protectiv shield in place.
If a product run is short or product rows are narrow and/or low, set protective shield closer to the pickup
prongs; otherwise move the protective shield away from the pickup prongs.
7.6.6 CUTTING ASSEMBLY (Z589-2… only)
If the machine is equipped with the cutting assembly, the product can be cut (shredded) when being picked up.
Extend the cutting blades into the baling chamber by operating the control terminal to cut the product.
IMPORTANT!
Turn on the F Bus system and – depending on the control terminal type – follow the blade
extension and withdrawal instructions in the following Chapters:
• QuickTronic = 10-QT.3.4 Cutting assembly.
• EasyTronic = 10-ET.6.3 Cutting assembly.
The cut-off spacing is 77 mm.
If the product is to be cut into longer pieces, some blades need to be removed.
See Chapter 9.9 " Cutting assembly maintenance and adjustment " for more information about adjusting, replacing
and maintaining the blades.