Metal-Fach Z589, Руководство по эксплуатации и техническому обслуживанию

Страница: 41 / 145

page 38
Z589
Round Baler
7.6.7 SELECTING THE CORE TYPE
The F Bus control system facilitates setting the bale core diameter and density depending on the material type
and individual needs.
The mechanical sorting function facilitates rolling bales with soft or hard cores.
Adjusting the core type:
The bale core adjustment pin is located under the side guards on both front sides of the baler.
You can roll bales with a hard core and four types of soft core:
Note : The bale soft core size must be less than the bale diameter.
Bale diameter ≤ 1.2 m: select the setting 1 or 2.
a) The hard core bales are produced with the pin
S installed at any position and fastened with the
plug C .
b) The soft core bales are produced with the pin S
installed in a soft core position and fastened with
the plug C .
To insert or remove the pin
S
, set the belt tensioning main arm in the maximum position by moving the tractor to
clear the pin holes.
IMPORTANT!
• The pins must be on one level on both sides of the machine.
• Make sure that the belt tensioning main arm is over the pin holes (it MUST NEVER be below
the pin holes).
Pin S positions (level on the left and right-hand sides):
1) Bale with small soft core .............................................................. ø = 50÷60 cm
2) Bale with average soft core .......................................................... ø = 70÷80 cm
3) Bale with average/large soft core ................................................. ø = 85÷90 cm
4) Bale with large soft core (star-shaped) .................................... ø = 100÷110 cm