Metal-Fach Z589, Руководство по эксплуатации и техническому обслуживанию

Страница: 68 / 145

page 65
Z589
Round Baler
9.6.2 NET WRAPPER
The F Bus control system can be use to preset the number of bale winds. See the following Chapters for the
information on modifying the settings:
• EasyTronic = 10-ET.5.1 Program menu.
CAUTION ! Before attempting any maintenance or adjustment of the net wrapper:
• Stop the tractor, remove the ignition key and wait until all machine parts stop
completely.
• Turn off the control system.
Adjusting the net feeding arm movement:
Adjust the movement of the net feeding arm BR relative to the intermediate roller R by operating the relevant
adjustment screw VR located on the stop F :
CAUTION!
Be careful when working close to the net wrapper arm and the wrapper blades.
• Open the right-hand side guard panel.
• Remove the nut d and then loosen or tighten
the adjustment screw VR to set the correct
distance between the net feeding arm BR and the
intermediate roller R .
Please note:
• If the screw VR is overtightened, the net feeding arm may shift out of alignment and start rubbing
against the roller when wrapping.
• If the screw VR is too lose, the range of motion of the net feeding arm may be insufficient and prevent
the net from being fed, resulting in failure to wrap the bales.
• Once finished adjusting, retighten the nut d and close the guard panel.