Mesutronic METRON 07 C, Перевод оригинального руководства пользователя

Страница: 62 / 84

-60- Errors and Problems
1-015 Error: „Reject unit: rejection failure“
Check the function of your separation unit.
1-016 Error: “Reject unit: no reject unit configured”
Please configure a switching output as a reject unit. Contact the service department.
If the message is ignored and no switching output is changed to a separation unit, no separations will be
counted (menu item: reject counter). The display is limited to 5 messages (power-on procedures).
see chapter Adjustment

Operating level 1

Reject counter
1-017 – 1-018: reserved
1-019 Error: „System monitoring: 24 V external voltage“
The voltage is not within the tolerance range. Contact the service department.
1-020 Error: „System monitoring: 24 V voltage “
The voltage is not within the tolerance range. Contact the service department.
1-021 Error: „System monitoring: 5 V voltage“
The voltage is not within the tolerance range. Contact the service department.
1-022 Error: „System monitoring: 3.3V voltage “
The voltage is not within the tolerance range. Contact the service department.
1-023 Error: „System monitoring: 1.8V voltage “
The voltage is not within the tolerance range. Contact the service department.
1-024 Error: „System monitoring: 1.2V voltage “
The voltage is not within the tolerance range. Contact the service department.
1-025 Warning: „System monitoring:
Battery voltage too low“
The battery voltage is too low. The battery must be replaced.