Mesutronic METRON 07 C, Перевод оригинального руководства пользователя

Страница: 33 / 84

-31- Assembly
Supply voltage
Connect the supply voltage only after you have integrated all connections. Otherwise there will be error
messages.
The supply voltage has to lie within the following bounds:
100 to 240 V AC
50 / 60 Hz
Power protection: max. 10 A
Special version : Operating voltage: 20 to 36 V DC
Please note:
For the mains plug of the customised version, the electronics and, if present, the frame must
be included in the earth potential! The metal detector (coil) is to be set up isolated, as usual.
see chapter Introduction  General notes on metal detection  Electrostatic discharges
If you do not use the mains plug of the shipped package, you have to configure the mains connector as
follows:
● The electrical safety and installation provisions of the respective country must be
observed.
● The mains voltage must be separable, i.e. it must be possible at any time to
separate the device from the electrical power system.
● The applied power connection/mains socket must be in visible near of the device
and be well accessible.
● Repair and maintenance work on the board may only be carried out by trained
and authorized personnel!
● Improper adjustments can impair or even prevent your metal detector from
operating!