Mesutronic METRON 07 C, Перевод оригинального руководства пользователя

Страница: 20 / 84

-18- Actuation
Actuation manual
1. Clean the metal detector
If the product is not allowed to have contact with foreign matter, all surfaces having contact with the product
must be cleaned before start-up operation.
Please follow the safety instructions!
see chapter Maintenance and cleaning  Cleaning
2. Assemble metal detector
Assemble the metal detector according to the information provided in the chapter „Assembly“.
see chapter Assembly
3. Connecting the 24V switching exits and relays
Connect the 24V switching exits and relays as needed. Please follow the indications in the chapter Set-up .
see chapter Assembly  Connection
4. Connect power supply
see chapter Assembly  Connection  Supply voltage
5. Switch metal detector on
Having assembled the detector mechanically, as a first step it is taken into operation. Under this condition
the detector is only subject to external influences (peripheral disturbances). If at this point faulty responses
are triggered, you have to try and find the source of the disturbance and to correct the error. For this switch
off all machines (motors, actuation, etc.) in the direct surroundings of the metal detector so that the metal
signal of the metal detecting device stays within the triggering range. As a next step the device is taken again
into operation step by step.
After each step control the measure signal in order to locate the disturbance, that causes an increased noise
level. If a noise suppression is not possible, remains only an increase of the detection threshold, until there
are no more false alarms.
see chapter Adjustment  Operating level 1  Detection level
The metal detector is now fully assembled and connected.
All further points are concerned with the most important adjustments
that should be made to your machine in order to ensure trouble-free
operation with the maximum possible sensitivity.