Mesutronic METRON 07 C, Перевод оригинального руководства пользователя

Страница: 54 / 84

-52- Adjustment
Code input required
Code Input Required specifies whether a detector test can always be aborted ( OFF ) or whether a login with
an appropriate user is required ( ON ) in order to abort. The same applies to the confirmation of the timeout
error message (“Detector test failed: Timeout”). This prevents a failed detector test from being reset by
unauthorised persons.
see chapter Adjustment  Operating level QM  User administration
Test piece learning (optional)
When ‘learning’, the plant waits for a test body to be introduced into the detector. After metal has been
detected, the values for the test body are displayed and saved with ‘
OK ’ in order to be compared to the
results of the automatic test with signal tolerance and angle tolerance activated.
It is possible by actuating the test body number to give this test body a name. After that the name of the test
body will be used when requesting a test body to be placed. e.g. ‘Please place ferrite’. Result: ‘1 ferrite:
222/63’
If no test body has been configured, the test bodies are distinguished by test body number.
Signal tolerance The selected value indicates the maximum
amount by which the metal signal generated
by the detector may deviate from the learnt
setpoint value. OFF (0%) to 50%
Factory setting: OFF
Angle tolerance Analogous to signal tolerance OFF (0°) to 50°
Factory setting: OFF
Test piece count
Number of test bodies required for the detector test. (Standard: 3 test bodies)
Test piece confirm
If this option is activated with ‘YES’ , the user must confirm each placement of a test body before placing it
by actuating the corresponding button ‘Test body ready’; only then is the test body detection activated.
Metal data capture time
The separation mechanism can be configured so that no separation takes place during a detector test.
CAUTION!
If Metal data capture time is set to ‘NO’ , then no separation takes place. This means that any
metal parts present in the product stream during the test will also not be separated!