Technical Manual
Glass Room Temperature Controller Smart SCN-RTRGx.02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
•
Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
100
100
The parameter "
LED colour on button activation
" defines the colour change (valid for all status
LEDs) when a button is activated, if these are assigned twice by the setting "LED reacts to"
"external/internal object and button activation". In this case, the colour settings in the menus "LED
1-4" refer to the control via the object. The global parameter "LED colour on button activation"
defines the behaviour on button activation.
Example:
LED 1 reacts to external object with DTP "Switch". Colour "blue" with value
“
ON
”.
"LED colour on button activation" is set to "orange".
If LED 1 now receives a "1" via the external object, LED 1 lights up blue. If key 1 is now pressed,
LED 1 lights up orange for approx. 3 seconds. Then the colour changes back to blue.
Blinking status LEDs can be synchronised via the flashing status
synchronisation object
. In this
way, it is possible to ensure that all LEDs in a room flash in the same rhythm. One push-button in
the room is defined as master and all other push-buttons as slaves. The objects LED flashing status
are linked together in a group address.
The following table shows the available communication objects:
Number Name/Function
Length Usage
81
LED
–
Blocking object
1 Bit
Blocking of all LED´s
92
LED
–
Blinking status
1 Bit
Synchronising the flashing status
Table 109: Communication objects
–
LED basic settings
4.6.2 LED 1-4
The following figure shows the available settings for each of the active LEDs:
Figure 58: Settings
–
LED 1-4