Maschio ATTILA 250, Использование и обслуживание

Страница: 34 / 114

USE AND MAINTENANCE
ENGLISH
34
cod. F07011124
- Check the tightness of the hydraulic system, and replace
defective hoses immediately; use only original spare parts.
- Keep the warning stickers on the machine in legible condi-
tion.
CAUTION
- The use of non-original or stronger pins may lead to serious
damage to the equipment.
- Lower the seed drill when the tractor is in forward gear, to
avoid clogging or damage to the planter shoes; for the same
reason the tractor should not reverse when the seed drill is
on the ground.
- Maintain a work speed compatible with the type of soil and
tilling in order to avoid breakages or damage.
ATTENTION
The demounting of the axes that hold the mobile elements can
cause the falling of the posterior rollers, and there is the risk
of crushing or perforation the operators legs.
3.5.6 METAL TANGS AND FINS
Thanks to this accessory, the soil explosion is kept under control
through a series of adjuster holes (Fig. 15).
The metal tangs are
fi tted directly onto the anchor in their hole
particular.
3.5.7 CONTAINING FLAPS (OPTIONAL)
This accessory is applied to the side of the equipment and ensures
that the clods of earth and kept within the area, preventing them
from falling onto the cultivated part or the part still to be worked
Before transiting on the road, withdraw the
fl aps within the bounds
of the machine and block them into place using the bolts, as shown
in Figure 16.
CAUTION
Danger of cutting hands while working and handling the
equipment.
3.6 BEFORE STARTING WORK
Before starting the seeding operation grease all parts indicated by
transfer nr. 9 (‘GREASE’) at page 29 of this lea
fl et.
3.7 DURING WORK
Always respect the following rules for successful sowing:
- Keep the hydraulic hoist in the position that allows the equip-
ment to work parallel to the ground.
- Every now and then check that the screws are tight enough;
in particular, tighten the nuts of the vehicle wheels. For new
machines or after repair, tighten all the screws after the
fi rst
10 ha.
- Check the safety of the tensioner bolts for integrity and dam-
age. Check the safety pins (integrity, damage) and replace
them if necessary.
- Check for possible defects in the pins of the upper and lower
arm and of the chains with split pins.
- Check the condition of the bearings and the gaskets: dam-
age and wound-round material (metal wires, wires, plant
residues, etc.) should be eliminated immediately.
- Check the integrity of the bearings.
- Check that the locking device for transport is working
properly.
fi g. 15
fi g. 16