CDM816D WHEEL LOADER
3
1.1.3
Incorrect operation, maintenance or repair is dangerous and may cause personnel
casualties.
1.1.4
After power-on but before startup, please sound the horn twice to alarm the people around to
watch out, for the loader is ready to start; the loader is shut down electrically under the control of key.
For this purpose, shift to the ”OFF” position and keep for 3-5s; return to the power-off gear to cut off the
power after the engine has been stopped, and then take out the key to avoid electricity leakage and
other accidents.
Always remember to disconnect the power when parking
to ensure the safety of
personnel and machine; cut off the master power switch after each operation to avoid electricity
leakage.
1.1.5
Unauthorized modification to the machine may damage its functions or weaken the safety
and influence its service life.
1.1.6
In case of any machine faults, please have it repaired at the designated special service
center and purchase the special LONKING accessories.
1.1.7
Please use the LONKING special oil when replacing or refilling with oil (grease); notice that
the fuel tank is on the right side in the forward direction of the machine and the hydraulic oil tank on the
left side. When servicing (refilling with) oil, never mix the oils at different grades and from different
manufacturers together; it is a must to apply the LONKING special brake fluid, for the inacceptable
brake fluid may lead tobrake locking, insufficient braking force or brake failure, thus causing machine
non-operation and even safety accidents.
1.1.8
If the brake plate of the caliper brake has been worn for 2/3, replace it with a new acceptable
one; or else, braking may be failed.
1.1.9
Do not adjust the set pressure of the hydraulic system on your own.
1.1.10
The vehicle speed shall be slowed down to lower than 4km/h upon shoveling and loading
materials. Never insert the bucket into the material by means of impact force and never lift the boom
mandatorily when the bucket has not been retracted; or else, the machine parts may be damaged
seriously.
1.1.11
It is a must to park the vehicle and shift to neutral position before changing the driving
direction (from forward to backward or vice versa) to prevent the transmission parts from damage due
to inertia impact of machine parts.
1.1.12
During the long-distance transfer by yourself, keep driving at medium/low speed and never
drive at high speed.
1.1.13
When topping up or performing repair, pay highly attention to keeping the cleanness of oil
(grease) and machine parts; or else, the system may be so contaminated to accelerate the machine
wear and even substantially shorten the machine service life.
1.1.14
Replace the damaged protective sleeves immediately to avoid other serious malfunctions.
1.1.15
Safety precautions and warnings are included in the manual and product. The ignorance of
these warnings may lead to the personal casualties and economic losses of yourself or others.
1.1.16
Dangers shall be identified with the “safety warning symbols” and such “label texts” as
"Danger", "Warning" and "Caution".
