CDM816D WHEEL LOADER
19
1.5.16.4 Unless there are additional seats and seat belts on the machine, it is not allowed to carry
people.
1.5.16.5 In the operation of machine, pay attention to and report where is in need of repair.
1.5.16.6 Do not come near the edge of the cliffs, tunnels and precipices.
1.5.16.7 Do no operate the machine across the slope. Whenever possible, make the machine toward
the uphill and downhill in the operation. Once the machine is sliding on the slope, you shall
immediately remove the load and turn the machine to the direction of downhill.
1.5.16.8 Avoid any situation that might cause the machine to tip over. The machine may tip over at the
shore and sloping land or across the trenches, ridges or other unexpected obstacles.
1.5.16.9 Maintain control of the machine, and do not let the load to exceed the capacity of machine.
1.5.16.10
Ensure the enough hooks and drag devices. Traction devices can only be connected to
the traction pin or hook. Do not let people straddle the steel rope.
1.5.16.11
Before mobilizing the machine, make sure that no personnel is between machine and
equipment. Support the traction equipment and align it to the traction pin, and connect the machine to
the equipment for dragging. You shall know the maximum size of the machine.
1.5.17
Shutdown of engine
1.5.17.1 After the engine is working under the load, do not immediately stop the engine, which may
cause the overheating and accelerated wear of the engine parts.
1.5.17.2 After the machine is stopped and parking brake is engaged, let the engine run for five
minutes and then shut it down, which allows the high-temperature parts in the engine to cool down.
1.5.18
Parking
1.5.18.1 Park the machine on level ground. If the machine must be parked on a downhill ramp, wedge
the tyres.
1.5.18.2 Stop the machine with service brake. Engage the transmission controller into neutral position.
1.5.18.3 Apply the parking brake.
1.5.18.4 Shut down the engine.
1.5.18.5 Turn the starting switch of the engine to OFF position and remove the key.
1.5.18.6 Turn the master power switch to
○
position so as to prevent the possible battery discharge
due to the short circuit, leakage of certain parts or vandalism.
1.5.19
Operation on slope
1.5.19.1 Different machines have the different performances. Safe operation under the different
conditions depends on the configuration, maintenance, running speed, working place, tyre pressure,
etc. The most important thing is the driving skill and judgment of operator.
1.5.19.2 Operator shall receive the good training of operating skills, and these training courses shall
equip the students with the ability to observe the working and environmental conditions, control the
