CDM816D WHEEL LOADER
17
1.5.10 Pipeline
1.5.10.1 Do not bend or knock the high-pressure pipelines. Do not install any bent or damaged
pipeline.
1.5.10.2 Repair all loose or damaged pipelines. The leakage may cause fire. Consult the LONGKING
agents about the matters for repairing or replacing the parts.
1.5.10.3 Carefully check the pipelines, and please check for the leakage with wooden board or
cardboard other than bare hands.
1.5.10.4 In case of any of the following conditions, replace the parts:
1.
End fitting is damaged or leaked;
2.
Outer layer is worn or cut;
3.
Metal wire is exposed;
4.
Outer layer is swelled;
5.
Hose is distorted;
6.
End fitting is moved.
1.5.10.5 Make sure that all the folders, shields and insulation boards are installed correctly. This helps
to prevent the vibration of machine and the wear and overheating of parts.
1.5.11 Tyredescription
1.5.11.1 The explosion of pneumatic tyre is caused by the gas explosion due to the internal heating,
and the explosion due to the heat source may be caused by the welding, heating on the rim parts,
outside spark or excessive brake.
1.5.11.2 Tyre explosion is more lethal than the rupture. Its explosive power may cast the tyres, rim
parts and axle parts from the machine for 500m or even farther. The explosive power and the cast
parts may cause damage to buildings and casualties.
1.5.11.3 Do not come near the hot tyre. Do not use water or calcium as the counterweight. It is
recommended to inflate the tyre with the dry gas. In order to avoid the excessive inflation, it is
necessary to provide the professional inflating equipment and the training for the proper use. Improper
equipment or incorrect use will cause tyre rupture or rim damage.
1.5.11.4 In the process oftyre inflation, stand behind the tread and use theclampprovided.
1.5.11.5 It is dangerous to repair the tyres and rims, so the repairshall be performed by the specially
trained personnel with the right tools and work procedures. When repairing the tyres and rims, the
incorrect procedure may lead to the explosive power which may burst the installation pieces, resulting
in casualties.
1.5.12
Prevention of lightning injury
1.5.12.1 In case of lightning near the machine, operator shall not conduct the following operations:
1.
Board the machine;
