Operation Manual
40
②
For hard pavement, the boom control lever shall be in the floating position, and for soft pavement,
it shall be in the neutral.
③
Engage the reverse and level the ground with the scraper.
(7) Traction
①
Securely fix the towing tractor to towing pin.
②
Put the working device in the transport state.
③
The start and stop shall be gentle and slow, and the braking system shall be checked prior to
driving down the slope and the brake of towing tractor shall be applied when transporting the materials
on the road with greater gradient, to ensure the driving safety.
(8) Hoisting
The hoisting can be performed by mounting appropriate sling.
IV. Lubrication
Correct lubrication can significantly reduce the frictional resistance to the loader and wear to parts,
thus ensuring the normal operation of the loader and extending its service life.
(i) Notes on fuel filling:
1.
Clean the fuel filling containers and parts, in case of damage to butter nipple, immediately replace
it.
2.
Always maintain the loader in a level state when checking the oil quantity
3.
For the front and rear axles, add from the oil filling hole in the left and right wheel housings until oil
spills from the oil level plug in axle housing.
4.
For the transmission, the upper oil level check plug shall be taken as the benchmark, and the oil
level shall be between the upper and lower oil level check plugs. The working oil tank shall be filled up
to the oil pointer (higher than the lower oil pointer hole or lower than the upper oil pointer hole). In the
filling for the first time, start the engine and allow it to run for 5 min and check the oil level again.
(ii) Type and grade of lubricant (See Table 2-1)
(iii) Adding oil and injecting grease with pressure
1.
Engine oil
Engine oil is used for the engine lubricating system.
The marking line “Static Full” on the oil dipstick indicates the oil level required before the diesel engine
starts; the “Dynamic Full” indicates the oil level required to maintain when the diesel engine is running;
the “Danger” indicates that oil shall be added immediately.
2.
Oils for torque converter and transmission
Add oil from the transmission oil filler until the oil can drained from the drain plug. The minimum oil
level shall not be lower than the drain plug after the engine starts. The oil is used for torque
transmission and lubrication.
