CDM816D WHEEL LOADER
37
2.
Operation mode
(1) Loading
Generally, loading can be done in the following two ways:
As shown in Fig. 2-4 (A), the distance between (1) and (2) is 10m, and the freight vehicle shall be
stationaryto ensure higher operation efficiency.In Fig. 2-2 (B), the loader and the freight vehicle are
combined to perform the operation, which is appropriate for continuous transport of the fleet.
Fig. 2-4 Schematics of Loading Modes
(2) Shovel-loading
①
Head for the material pile with gear I applied, and the lower hinge point of the boom shall be
250mm above the ground and the bucket shall be parallel to the ground, as shown in Fig. 2-5 (a).
②
When the loader is 1m from the material pile, lower the boom to make the bucket bottom touch the
ground and horizontally stretch into the pile.
③
Depress the throttle to make the bucket fully stretch into the material pile, and the digging and
loading shall be combined in case of great resistance, i.e. operate the bucket interruptedly to rotate
upward and lift the boom at the same time, until the bucket is full.
④
When the bucket is full, lift the boom up to the required height, and then shift the boom control
lever to the neutral.
