Operation Manual
20
machine and identify the potential danger.
1.5.19.3 In the operation on the slope, you shall consider the following important factors:
1.
At the higher speeds, the stability of the machine will deteriorate due to the inertia;
2.
In the rugged terrain, the stability of the machine will deteriorate;
3.
Machine will slip on the meadow, muddy road and gravel road;
4.
Maintain the balance of machine;
5.
Overweight loads may cause the machine to tip over;
6.
Do not operate across the slope, the machine shall be toward the uphill or downhill any time;
7.
Operating the machine on the slope will affect the play of performance and increase the instable
and unsafe factors.
8.
If the machine has to be parked on a slope, add wedges under the tyres to prevent the machine
moving.
1.5.20
Containing of spilled fluids
1.5.20.1 Carefully perform the inspection, maintenance, testing, adjustment and repair, and ensure
that the spilled fluids are contained properly. Before opening any chamber or removing any parts
containing fluids, prepare the appropriate container to hold the fluid.
1.5.21
Operation safety on rainy, snowy and foggy days
1.5.21.1 The machine’s operations will be affected on rainy, snowy and foggy days and operation
safety should be paid full attention to.
1.5.21.2 In case of low visibility, clearance lamp and illuminating lamp must be turned on to facilitate
the operation.
1.5.21.3 Machine is likely to slip on a muddy, snowy or frozen road, thus it is recommended to install
tyre chain or adjust the load appropriately, and the driving and operation speed should be slowed
down and sudden braking, stopping and turning shall be avoided.
1.5.21.4 Ona frozen road, the ground will become soft if the temperature rises and the road surface
condition is unstable. Operator shall drive very carefully to prevent insufficient driving force or sinking
of the whole machine.
1.5.21.5 After a heavy snow, the debris at the road shoulder and road side are buried and difficult to
discover. Sweep the snow carefully to prevent damaging the tyre.
1.5.22
Notes in cold climate:
1.5.22.1 For working in cold climate, adequate measures should be taken to ensure that the machine’s
working performance will not be affected. Preheat the machine before operation. Before starting to
operate the control lever, fully preheating the machine can prevent slow response of the machine and
avoid accidents.
1.5.22.2 Operate the control levers and circulate the hydraulic oil in the hydraulic system (increase the
