Lenovo ThinkServer RD210, Руководство по техническому обслуживанию аппаратной части

Страница: 135 / 182

1
Battery retention clip
2
Battery
3
Posts
4
Battery mounting slots
5
Rings
6
Microprocessor 2 air baffle
7
Posts
• Take the battery retention clip and place it underneath the other tab while pressing release tab
toward the front of the server; then, press it down until it snaps in place to hold the battery carrier
firmly in place.
6. Install the cover (see “Removing and replacing the cover” on page 72).
7. Slide the server into the rack.
8. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.
Removing and installing the bezel
To remove and install the bezel, complete the steps in this section.
Removing the bezel
To remove the bezel, complete the following steps:
1. Read the safety information in Chapter 2 “Safety information” on page 3 and “Installation guidelines”
on page 67.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the hard disk drives and filler panels from the hard disk drive bays (see “Removing and installing
a hot-swap hard disk drive” on page 78).
4. Remove the screws 1 from the bezel 2 .
Chapter 7
.
Installing optional devices and replacing customer replaceable units
127