Lenovo ThinkServer RD210, Руководство по техническому обслуживанию аппаратной части

Страница: 121 / 182

Installing the system board
Notes:
1. When reassembling the components in the server, be sure to route all cables carefully so that they
are not exposed to excessive pressure.
2. When you replace the system board, you must either update the server with the latest firmware or restore
the pre-existing firmware that the customer provides on a diskette or CD image.
Important: Some cluster solutions require specific code levels or coordinated code updates. If the device is
part of a cluster solution, verify that the latest level of code is supported for the cluster solution before you
update the code
To install the system board, complete the following steps:
1. Read the safety information in Chapter 2 “Safety information” on page 3 and “Installation guidelines”
on page 67.
2. Grasp the fan assembly brackets and rotate them down toward the chassis.
000000
000000
000000
000000
000000
0
0
0
000000
000000
000000
000000
000000
3. Grasp the fan assembly brackets and rotate them down toward the chassis.
4. Reinstall the hot-swap fans (see “Removing and installing a hot-swap fan assembly” on page 100).
5. Reinstall the microprocessor and heat sink.
6. Reinstall the SAS/SATA RAID riser-card assembly base (see “Removing and installing the SAS/SATA
RAID riser-card assembly” on page 102).
7. Reinstall the DIMMs (see “Removing and installing the DIMM air baffle” on page 77).
8. Reinstall the microprocessor 2 and DIMM air baffles (see “Removing and installing the microprocessor 2
air baffle” on page 76 and “Removing and installing the DIMM air baffle” on page 77).
9. Reinstall the PCI riser-card assemblies and adapters, if any were installed (see “Removing and installing
the SAS/SATA RAID riser-card assembly” on page 102).
10. Reinstall IMM Premium (see “Removing and installing the virtual media key” on page 119).
Chapter 7
.
Installing optional devices and replacing customer replaceable units
113