Lenovo System x3750 M4, Инструкция по установке и обслуживанию

Страница: 87 / 982

Table 16. Supported adapters, slot in which to install the adapters, and information about the adapters. (continued)
Name of adapter
Suggested slot
installation
sequence
Notes
Intel I350-T4 ML2 Quad Port
GbE Adapter for System x
Install in the ML
adapter slot on the
system board.
• Port 1 on the adapter is the default port for IMM Shared mode
when enabled through UEFI.
• This adapter provides the following features:
– Single chip, quad-port 1 Gb Base-T controller with
integrated MAC and PHY
– PCI Express v2.1 with 5.0 GT/s and 2.5 GT/s support for
x1, x2, and x4 links widths
– Pass-Through (PT) functionality via a sideband interface
– DMTF Network Controller Sideband Interface (NC-SI)
– 1000BASE-T, 100BASE-TX, and 10Base-T link modes
– Flexible port partitioning (32 virtual functions on quad-port
or 16 virtual functions on dual-port)
Emulex VFA5 ML2 Dual
Port 10GbE SFP+ Adapter
for System x Install in the ML
adapter slot on the
system board. • Port 1 on the adapter is the default port for IMM Shared mode
when enabled through UEFI.
• This adapter supports FoD and requires a license or key
(Emulex VFA5 ML2 FCoE/iSCSI License for IBM System
x (FoD)) if you want access to FCoE and iSCSI advanced
features.
• For this adapter, you will need supported SFP transceivers or
DAC cables to connect to your Fibre connections.
• This adapter provides the following features:
– Four SFI 10 Gb Base-R Ethernet interfaces
– PCIe Gen3 x8 interface
– Single Root I/O Virtualization (SR-IOV)
– Ethernet network interface (Layer 2 NIC) and TCP/IP
– Fibre Channel over Ethernet (FCoE)
– Remote Direct Memory Access (RDMA)
Broadcom NetXtreme II
ML2 Dual Port 10GbE SFP+
Adapter for System x Install in the ML
adapter slot on the
system board. • Port 1 on the adapter is the default port for IMM Shared mode
when enabled through UEFI.
• This adapter provides the following features:
– PCIe Gen2 x8 dual-port 10 Gb SFP+ controller in 50 mm
wide ML2 form factor
– TCP/IP Offload (TOE), Wake on LAN (WoL), UCM and CIM
capable
– Supports standard pNIC or vNIC2 modes
– Unified networking delivering LAN and iSCSI over 10 Gb
SFP+
– Two independent 10 Gbp SFP+ interfaces with SR-IOV
capability
– PCI Express v2.1 with support for x8 link width, accepts
both FTP+ SR optical and SFP+ DAC cables
Chapter 2
.
Installing optional devices
73