Lenovo System x3750 M4, Инструкция по установке и обслуживанию

Страница: 161 / 982

host name from the IMM network access tag. The server comes with a default IP address for the IMM2 of
192.168.70.125. To obtain the IP address, complete the following steps:
Step 1. Turn on the server.
Note: Approximately 10 seconds after the server is connected to ac power, the power-on button
becomes active.
Step 2. When the prompt
<F1> Setup
is displayed, press F1. If you have set both a power-on password
and an administrator password, you must type the administrator password to access the full
Setup utility menu.
Note: This prompt is displayed on the screen for only a few seconds. You must press F1 quickly.
Step 3. From the Setup utility main menu, select System Settings .
Step 4. On the next screen, select Integrated Management Module .
Step 5. On the next screen, select Network Configuration .
Step 6. Find the IP address and write it down.
Step 7. Exit from the Setup utility.
Logging on to the IMM2 web interface
Use this information to log on to the IMM2 web interface.
To log on to the IMM2 web interface, complete the following steps:
Step 1. On a system that is connected to the server, open a web browser. In the Address or URL field,
type the IP address or host name of the IMM2 to which you want to connect.
Note: If you are logging on to the IMM2 for the first time after installation, the IMM2 defaults to
DHCP. If a DHCP host is not available, the IMM2 assigns a static IP address of 192.168.70.125.
The IMM network access tag provides the default host name of the IMM2 and does not require
you to start the server.
Step 2. On the Login page, type the user name and password. If you are using the IMM2 for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the system-event log.
Note: The IMM2 is set initially with a user name of USERID and password of PASSW0RD (with
a zero in the word password, not the letter O). You have read/write access. You must change
the default password the first time you log on.
Step 3. Click Log in to start the session. The System Status and Health page provides a quick view
of the system status.
Note: If you boot to the operating system while in the IMM2 GUI and the message “Booting OS or in
unsupported OS” is displayed under System Status
→
System State , disable Windows 2008 firewall or type
the following command in the Windows 2008 console. This might also affect blue-screen capture features.
netsh firewall set icmpsetting type=8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM2 GUI will then change to “OS booted”
status after you change the setting as indicated above in both the Web and CLI interfaces.
Logging on to the IMM2 CLI interface using Telnet
Use this information to log on to the IMM2 web interface using a Telnet protocol.
To log on to the IMM2 CLI interface using Telnet, complete the following steps:
Chapter 3
.
Configuration information and instructions
147