Lenovo System x3750 M4, Инструкция по установке и обслуживанию

Страница: 270 / 982

Step 1. Read the safety information and installation guidelines, see “Safety” on page v and “Installation
guidelines” on page 38.
Step 2. Touch the static-protective package that contains the new adapter to any unpainted metal surface
on the server; then, remove the adapter from the package.
Step 3. Align the edge connector on the adapter with the connector on the system board. Press the edge
of the connector
firmly into the system board connector and make sure that the adapter snaps
into the connector securely.
Attention: When you install an adapter, make sure that the adapter is correctly seated on the
system board connector before you turn on the server. An incorrectly seated adapter might cause
damage to the system board or the adapter.
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Step 4. Close the adapter retention latch.
Step 5. Reconnect any cables that you disconnect earlier.
Step 6. Perform any configuration tasks that are required for the adapter.
Step 7. Replace the cover (see “Replacing the server top cover” on page 216).
Step 8. Slide the server into the rack.
Step 9. Reconnect the power cord and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.
Removing the ML2 Dual-port 10Gbase-T Adapter for IBM System x or ML2 Dual-port
10 GbE SFP+ Adapter for IBM System x
Use this information to remove the ML2 Dual-port 10Gbase-T Adapter for IBM System x or ML2 Dual-port 10
GbE SFP+ Adapter for IBM System x.
To remove the ML2 Dual-port 10Gbase-T Adapter for IBM System x or ML2 Dual-port 10 GbE SFP+ Adapter
for IBM System x , complete the following steps:
Step 1. Read the safety information and installation guidelines, see “Safety” on page v and “Installation
guidelines” on page 38.
256
Lenovo System x3750 M4 Installation and Service Guide