LaserPro Mercury II, Руководство пользователя

Страница: 59 / 77

- 58 -
Mercury II User Manual
5.2.3.3 Mercury II Print Driver >> Advance Page
Scaling (Advance Page)
[DEFAULT SETTING: 0]
In some cases you may find a slight output inaccuracy in the actual output compared to
what you have set in the computer. This margin of error or offset is extremely small
(approximately 1/300). What this means is that there may be a 1-unit offset for every 300
unit increments. As an example, if you engrave a 300mm straight line, it may end up
measuring only 299mm or 301mm in the final output. In this case, you will want to set the
scaling setting to +1 / 1000 or -1 / 1000 respectively to compensate. A general rule of
thumb is for every 300 unit increment, you will want to adjust the slider by +1 if the final
output is 1 unit increment shorter or -1 if the final output is 1 unit increment longer than
your graphic design setting.
Position Modes (Advance Page)
[DEFAULT SETTING: Home]
These selections allow you to control the positioning of the lens carriage after each job
completion and before the next subsequent job.
•
Home: Resets the positioning of the lens carriage to the ‘home position’ (upper-right)
before and after each job.
•
Without Home: The lens carriage will start the next job based on the position from its
graphic application software setting, from the last position of the previous job. Upon