LaserPro Mercury II, Руководство пользователя

Страница: 22 / 77

Mercury II User Manual
- 21 -
Chapter V - Operating the LaserPro Mercury II
Once you have installed the LaserPro USB Driver (USB connectivity only), LaserPro Print Driver,
and have connected the LaserPro Mercury II to your computer, you will need to familiarize yourself
with the LaserPro Mercury II’s control panel and LaserPro Print Driver. The print driver will be
where you spend most of your time configuring specific laser parameters for your jobs, while the
control panel will allow you to set repeat times, manipulate the file order, perform auto / manual
focusing, configure the start point, and more.
NOTE
If you are using the water-cooled model, be sure to power on your water chiller before
start operating Mercury II. Water chiller temperature is recommend to set around
18~22
℃
. If you forget to start water chiller first, the laser will not fire. To solve this
problem, just power on water chiller then restart Mercury II.
5.1 Using the Hardware
5.1.1 Adjusting the LCD Display Screen’s Contrast Setting
Depending on the lighting of your immediate work area, you may need to adjust the contrast of
LCD display screen. You may increase or decrease the contrast via the contrast adjustment wheel
found on the inside of the right shoulder. You can access this area by opening the front door and
looking inside to the right shoulder (as shown in the picture below).
LCD Display Screen’s
Contrast Adjustment
Wheel