LaserPro Mercury II, Руководство пользователя

Страница: 24 / 77

Mercury II User Manual
- 23 -
malfunctioning.
DIRECTIONAL AND SELECTION BUTTONS
„
„ Function (F1 / F2 / F3 / F4)
„ Four function buttons allow you to select various functions, which will change depending
on what section of the menu you are in. Each function button’s corresponding function
will be displayed right above its respective button on the LCD display screen. Please
note that in certain menus, not every function button will always be mapped to a
corresponding action. In these situations, that particular button will not have a function.
„ Directional ( U / V / Y / Z )
„ Four directional buttons allow you to navigate the selection cursor through the control
panel menu and adjust the value of specific settings. In general, the
U / V directional
buttons cycle through the various selections, while the
Y
/
Z
directional buttons adjust
the value of that particular selection.
„ Enter – Confirms the current selection.
„
Start / Stop – Allows you to start or stop engraving jobs, once those jobs have been
successfully loaded onto the system.
„
„ Delete - Provides quick access to delete the current job.
„
Pause – Pauses the current engraving process. Press again to resume the current
process.
„
Cutting Mode – Cutting mode key would access to the three options of cutting quality and speed
combination
LASER
The Laser hot key can easily switch the laser status between on and off . When the laser is off,
the laser carriage would start to work without laser firing after pressing START/STOP key to better
positioning the laser firing path. Once the position of laser firing is confirmed to be correct, then you
can press the LASER key again to enable the laser, and start to laser engraving or cutting on
materials.
Recall – The RECALL key makes the lens carriage applies the saved position as origin.