MERCURY II User Manual
- 3 -
QUICK MENU
1. Connect air exhaust system.
2. Setup computer and connect with engraving system properly.
3. Turn
ON
host computer system.
4. Install the MERCURY Driver. (for the first time use only)
5. Use Windows-based program (such as CorelDraw, PhotoShop, PhotoPaint, Illustrator,
CASmate, Signlab, EasySign, AutoCAD, etc.) to operate with the engraver.
6. Turn
ON
engraver. The lens carriage moves to the home position (upper left corner)
and the working table moves down 50mm approximately after system initialization. (If a
rotary attachment has been installed, the working table will move down to the bottom.)
7.
Auto-focusing:
under
STOP
status, put work-piece on the table, move X-axis (Please
refer to Fig. 3) and carriage by arrow keys to locate the lens carriage above the
engraving material (holding carriage by hands for prompt moving is acceptable under
STOP
condition but not recommended). Press
AUTO FOCUS
the table will move
upward and stop at the focal position automatically.
8. The following is an example by using
CorelDRAW V.11
. Please ready the engraving
graphic in CorelDraw, and follow the instruction below to start work.
1. Layout
2. Page
Setup
3. Set from Printer,
choose
Portrait
4. OK
5.
Edit desired file (picture etc.)
6. File
7. Print
8. Properties
9. Options,
choose
desired Mode
(refer to Fig. 11) then set up proper resolution,
power and speed
10. OK
11. Print
12.
File name is shown on LCD then press
START.
NOTE:
z
Turn on the air exhausting system before engraving.
z
The
maximum loading weight
of working table is
20 kg
.
NOTICE:
1. In order to match Mercury II driver’s color. Make sure your
CorelDRAW V.11
or
later
the
“Color Management off
” is disabling. Please fallow the steps:
Tools
Color Management
Color Management Off
OK.
2. When operating with
CorelDRAW V.11
or later version, please choose
Layout
Page Setup
Set From Printer
.
3. When using the available artworks from the Clipart of CorelDRAW,
to prevent the
hidden vector lines shown on your engravings
. Please do as follows:
Choose a file from Clipart, go to
Bitmaps
Convert to Bitmap,
after converting
the file
,
go to
Bitmaps
Mode
Grayscale
OK.
Содержание Mercury II
Страница 1: ......
Страница 49: ... 48 Mercury II User Manual ...
