LaCie Internet Space 2
Setting Up the Internet Space 2
User Manual
page 13
2.1. Power on the Drive
1. Connect the power supply to a wall outlet and to the LaCie
Internet Space 2 (
Fig. 03
).
2. Connect the Ethernet cable to the Ethernet port on the back of
the LaCie Internet Space 2 (
Fig. 04
). Connect the other end of
the Ethernet cable into an available Ethernet “out” port on your
router or hub (refer to your router or hub’s documentation if
necessary).
3. Push and hold the power button until the blue LED turns on, then
off, then on again, then release the button. The blue LED will
blink while the Internet Space 2 launches its services (
Fig. 05
).
When the light stops blinking, the drive is ready for setup.
Move on to
2.1. Power on the Drive
.
CAUTION:
Only use the AC adapter supplied with your specific
LaCie device. Do not use a power supply from another LaCie device
or another manufacturer. Using any other power cable or power
supply may cause damage to the device and void your warranty.
Always remove the AC adapter before transporting your LaCie drive.
Failure to remove the adapter may result in damage to your drive
and will void your warranty.
TECHNICAL NOTE:
You may use your LaCie drive when in a for-
eign country thanks to its 100-240 Volt power supply. To be able to
use this feature, you may need to purchase an appropriate adapter
or cord. LaCie accepts no responsibility for any damage to the drive
resulting from the use of an inappropriate adapter. Using an adapt-
er other than one authorized by LaCie will void your warranty.
Router or hub
IN
OUT
Fig. 03
Fig. 04
Fig. 05
