28
Important Note:
Even though pressing the rear power switch can
turn off the library power, following the above steps is recommended. To
avoid pressing the control buttons by accident, you can disable the control
buttons. For information on how to disable the switch, refer to section
3.8
Disabling the Buttons on the Front Panel
. After turning the LaCie AIT
Library power off, wait at least 10 seconds before turning it on again.
2.11 Initial Setup
Once the library has started, perform the initial setup as follows:
1) Set the date and time (section
2.11.1 Setting the Date and Time
).
2) Set the SCSI IDs of the LaCie AIT Library and AIT drives if necessary (section
2.11.2 Setting the SCSI ID
).
3) Set the cartridges (section
2.11.3 Setting the Cartridges
)
4) Configure the application programs on the host computer for use with the
unit.
Follow the instructions given in the application software manual to set up the
software for the library.
5) Connect to a network if necessary (section
2.11.4 Connecting to the
Network
)
2.11.1 Setting the Date and Time
Use the Configuration Menu of the control panel to set the date and time.
Important Note:
The date and time can also be set through a
browser. The date and time cannot be updated when the LaCie AIT Library is
off.
1) At the status display, press the [MENU] button for two seconds.
2) Press the
button four times to select “5.Configuration”, then press the
[ENTER] button.
Содержание 107416 - 1.6/4.16TB AIT3 2U 16SLOT
Страница 1: ...1 LACIE AIT LIBRARY USER S GUIDE...
Страница 40: ...40 The top page of the Library Administration Menu appears Example When using Microsoft Internet Explorer...
Страница 78: ...78 The top page of the Library Administration Menu appears Example When using Microsoft Internet Explorer...
