LaCie 107416 - 1.6/4.16TB AIT3 2U 16SLOT, Руководство пользователя

Страница: 23 / 115

23
2.7 Connecting to the Host Computer
Connect the LaCie AIT Library and the host computer with a SCSI cable. This
section explains general connecting steps. To connect, use the Ultra2 Wide
SCSI LVD cable. However, when using a model equipped with an AIT3 drive,
use an Ultra160 SCSI LVD cable. The library side uses the 68-pin half pitch
connector.
When connecting other SCSI devices together with the LaCie AIT Library, see
section
2.9 Connecting SCSI Peripheral Devices .
Warning!
•
Do not connect the LaCie AIT Library to the HVD (High Voltage Differential)
SCSI bus. If connected, the library or other devices on the SCSI bus may be
damaged.
•
When connecting the Wide SCSI cable, turn off all of the connecting
devices, including the LaCie AIT Library and the host computer.
•
When connecting the LaCie AIT Library as the last device on the SCSI bus,
be sure to attach the provided terminator.
•
In LVD (Low Voltage Differential) SCSI, make the total length of the SCSI
cable (internal and external), which connects the host computer and the
device at the end of the SCSI bus, shorter than 12 meters (39ft. 4.4in.).
(The length of the LaCie AIT Library internal cable is 2 meters (78.7in.)).
•
Using SCSI cables longer than 30cm (11.8in.) to connect between devices
is recommended.
•
SCSI cables cannot be branched.
Important Note:
•
For information about the SCSI bus, refer to section 8.7 SCSI
Specifications .
•
Prepare the necessary SCSI cables. For information about SCSI cable
specifications, refer to section
8.6 SCSI Cable and Terminator
Specifications .
1) Confirm that the power to the host computer and LaCie AIT Library are
turned off.
2) Attach the SCSI cable and terminator as shown in the next figure.
A) Use a SCSI cable to connect the LaCie AIT Library to the host
computer.
B) Attach the provided terminator to connector.