Kval Commander III, Руководство по эксплуатации

Страница: 130 / 168

About the Calibration Screens
4-15
KVAL Commander III Operation Manual
2.
Choose the axis to be calibrated,
a.X (Horizontal)
b.Y (Vertical)
c.Z (Depth)
3.
X-Axis: use a caliper to measure how much the chisel cut is off compared to the ver-
tical hinge cut with the router on the jamb.
4.
Y-Axis: use a caliper to measure how much the chisel cut is off compared to the hor-
izontal hinge cut with the router on the jamb.
5.
Z-Axis: use a caliper to measure the depth of the chisel compared to the correspond-
ing hinge route.
a.Take the caliper measurement, and enter it into the Z-axis box.
b.If the chisel is too deep enter it as a negative number.
c.If the chisel is too shallow, enter it as a positive number.
d.Repeat until chisel position is correct
6.
Click the “
Combine
” button to combine the two numbers to create reference.
Hinge Carriage Location
Calibrate the Hinge Carriage travel across the front section. Normally, investigate this if limits of
travel of the Head is out of specification.
a.Take the caliper measurement, and enter it into
the X-axis box.
b.If the chisel needs to move to the left, enter it as
a negative number.
c.If the chisel needs to move to the right, enter a
positive number.
d.Repeat until chisel position is correct.
Positive
Negative
a.Take the caliper measurement, and enter it into
the Y-axis box.
b.If the chisel needs to move down, enter it as a
negative number.
c.If the chisel needs to move up, enter a positive
number
d.Repeat until chisel position is correct
Positive
Negative