Kostal PIKO 1.5 MP, Руководство по эксплуатации

Страница: 43 / 80

1. The previously set reactive power characteristic curve is displayed
graphically (example in Fig. left).
2. Press
ESC
✓
The check list is shown.
Finish
has been selected in the check list and
SET
has been pressed.
One of 2 possible dialogues is displayed.
1.
Proceed as follows, depending on the respective dialogue:
n
Dialogue
Settings are incomplete
: Press
SET
and work
through the open items in the check list.
n
Dialogue
Are all settings correct?
:
Press
ESC
to correct settings or
2. Press and hold
SET
(> 1 s) to finish 1st commissioning.
✓
If
SET
was pressed for a longer time then the inverter starts anew
and synchronises itself with the grid (Fig. left).
You have completed the initial commissioning of the inverter.
4.8 Feed-in management
Depending on the country, photovoltaic systems must have the possibility
of being reduced in the fed-in effective power by the network operator. The
following products are recommended for implementing this legally pre‐
scribed specification:
n
Energy meters (B+G SDM630, Herholdt ECS3-80B, Carlo Gavazzi
EM24-DI, Janitza ECS3)
n
WEB'log from Meteocontrol
n
Solar-Log from Solare Datensysteme
n
Energy-Manager from Kiwigrid
The energy meter for the feed-in management is connected to the Modbus
RTU interface (RJ10) and must meet the preconditions described in
Ä
Chapter 3.6.7 „Modbus RTU“ on page 28
and Ä
Chapter 3.6.8
„Modbus RTU data connection cable“ on page 28
.
NOTICE!
The settings for feed-in management must be made in the
sub-menu
„Energy management“
.
Display char. curve
Finishing initial commis‐
sioning
Installation
11/2017 | DOC01664604 | KOSTAL operating instructions PIKO inverter 1.5 - 4.2 MP 43